wiking Miro 1 Einbauanleitung Seite 15

WIKING Miro 3, WIKING Miro 4, WIKING Miro 5 and WIKING Miro 6 with lower door
For a fresh air connection at the back of the stove (drawing 6):
1. Open the door (1) below the combustion chamber.
2. Loosen the screws (2) in each side of the vertical cover plate (3) in the back of the chamber by
using an Allen key. Lift up the cover plate, tilt the lower part forward and pull the cover plate out.
3. Pull the insulation sleeve (4) on to the flexi-hose (5) and lead the flexi-hose through the hole (6)
in the rear plate. Mount the flexi-hose on the connector bush (7) using the strap (8).
4. Hook the cover plate (3) back in place and tighten the two screws (2).
For a fresh air connection beneath the stove (drawing 7):
1. Open the door (1) below the combustion chamber.
2. Loosen the screws (2) in each side of the vertical cover plate (3) in the back of the chamber by
using an Allen key. Lift up the cover plate, tilt the lower part forward and pull the cover plate out.
3. Pull the insulation sleeve (4) on to the flexi-hose (5) and lead the flexi-hose through the hole (6)
in the bottom plate. Mount the flexi-hose on the connector bush (7) using the strap (8).
4. Hook the cover plate (3) back in place and tighten the two screws (2).
WIKING Miro 3, WIKING Miro 4, WIKING Miro 5 and WIKING Miro 6 with wood store
For a fresh air connection at the back of the stove (drawing 8):
1. Loosen the screws (2) in each side of the vertical cover plate (3) in the back of the chamber by
using an Allen key. Lift up the cover plate, tilt the lower part forward and pull the cover plate out.
2. Pull the insulation sleeve (4) on to the flexi-hose (5) and lead the flexi-hose through the hole (6)
in the rear plate. Mount the flexi-hose on the connector bush (7) using the strap (8).
3. Hook the cover plate (3) back in place and tighten the two screws (2).
For a fresh air connection beneath the stove (drawing 9):
1. Loosen the screws (2) in each side of the vertical cover plate (3) in the back of the chamber by
using an Allen key. Lift up the cover plate, tilt the lower part forward and pull the cover plate out.
2. Pull the insulation sleeve (4) on to the flexi-hose (5) and lead the flexi-hose through the hole (6)
in the rbottom plate. Mount the flexi-hose on the connector bush (7) using the strap (8).
3. Hook the cover plate (3) back in place and tighten the two screws (2).
15