Powering Up The Pen Tablet - Fujitsu FPC1701ATS Benutzerhandbuch

58_0536_00.book Page 14 Wednesday, August 22, 2001 9:07 AM
S t y l i s t i c L T P - 6 0 0 P e n T a b l e t - C h a p t e r T w o
Power Icon Appearance
Power icon displayed
continuously
Power icon blinking
Power icon not
displayed
* Information in Table 2-1, "Changing System States," on page 14 is supplied to help you understand
which system states your system can enter from the current system state. Refer to the procedures on
starting the system, shutting down the system, suspending system operation, and resuming system
operation given later in this chapter.
†
Your system may be configured to use either Suspend-to-RAM mode or Save-to-Disk mode.

Powering Up the Pen Tablet

Follow the procedure below to start the Stylistic LT P-600 pen tablet. Before you begin, confirm that
the system is in the Off state. To do so, observe the Status display. If the Power icon is not visible in
the Status display, the system is in the Off state or in Save-to-Disk mode and it is safe to perform this
procedure. If the Power icon is visible (either blinking or on continuously), do not perform this
procedure. See "System States" earlier in this chapter for details on operational modes represented
by the Power icon.
1. Ensure that the battery pack in your pen tablet is sufficiently charged, or connect an external
power source such as the AC adapter or auto adapter to your pen tablet. See "Status Display" in
Chapter 1 to determine the percentage of charge represented by the Battery Gauge icon in the
Status display.
2. Press the Suspend/Resume button to start the system.
After performing system initialization, the system starts the operating system installed on the hard
disk drive. Once the operating system is running, you can use the system.
14
Table 2-1 Changing System States
Current State
On State To enter the Off state, shut down the system
or using the Start menu on your system.
Idle State
To enter Suspend-to-RAM or Save-to-Disk
state, suspend system operation using either a
hardware or software suspend.
† To enter the On state, resume system
Suspend-to-RAM
operation by pressing the Suspend/Resume
or Standby
button.
To enter the Off state, resume system by
pressing the Suspend/Resume button, then
shut down your system.
Off State To enter the On state, start your system, or
or resume system operation by pressing the
† Suspend/Resume button.
Save-to-Disk
*
To Change State
†
1