Safety Instructions; Maintenance And Cleaning - Kerbl Hobbyfarming NOFROST Bedienungsanleitung

(EN) Thermal chicken shack, heatable

Safety instructions

Read the following instructions carefully before using the device. Keep these operating instructions in a safe place.
CAUTION!
Risk of physical injury to people and animals and material damage if used incorrectly!
• Ensure that the device is only used be people who have the professional skills required to do so.
• Keep out of the reach of children and frail people.
• The surface of the floor heats up to around 30 °C.
• Ensure that no flammable or easily combustible materials are placed near the transformer or the plug.
• Check the operating voltage specified on the mains plug. Only operate the device at the mains voltage specified.
• If technical data on the transformer (type plate) is or becomes illegible, do not use it.
• For the safety of humans, animals and property, the device must only be connected to mains sockets that are fused separately with a residual current circuit breaker (RCCB).
• Route all electrical supply cables so that they are protected against biting or gnawing. Only use gnaw/bite-proof materials.
• Do not allow electrical supply cables to come into contact with oil or sharp edges.
• Check the function of the heating element before the first frost.
• Do not use the heater if parts of the casing or supply cable are damaged.
• Do not try to repair a damaged supply cable yourself. The supply cable can only be replaced by the manufacturer.
• Do not pull the plug out of the socket using the cable and do not carry the heating element around by its cable.
• Always pull the plug out of the socket before modifying or cleaning the shack and its heated floor.
• Do not immerse in water.
• Note the maintenance and cleaning instructions.
• Only operate the heater if the floor is undamaged and all parts of the shack have been assembled correctly.
• If there is any damage to the floor, replace it immediately.
• Only connect the plug to the mains power if there is a risk of frost.
Correct use
The heatable shack is used to house poultry and protect them from frost. Any other use shall be deemed incorrect. In the event of the incorrect use of, tampering with or modifica-
tions to the device, the manufacturer's warranty and liabilities shall be deemed invalid.
The shack is used to house hens overnight. Give your animals adequate space to run around during the day. Ensure adequate ventilation inside the shack and comply with any
national legal requirements.
Function
The floor plate contains an electric heating conductor that evenly warms up the floor. The shack can be used indoors and out.
The heating element is switched on by the thermal switch if the temperature falls below the set minimum (approx. 6 °C) and switched off if the maximum set temperature is exceeded
(approx. 13 °C). This constantly maintains the air temperature between these values. The temperature of the floor is considerably higher, enabling water bowls to remain frost-free.
Setup and commissioning
Proceed as follows:
1. Check all parts and in particular the heatable floor, transformer and thermal switch for damage.
2. Assemble the shack in accordance with the enclosed instructions, paying attention to the safety information.
3. Connect the mains plug to the 230 V power socket. After a short time, you will be able to feel the warmth provided the thermal switch inside the shack detects that the
temperature has fallen below the minimum set temperature.
4. To switch off the heating, pull the plug out of the mains socket.
5. Only connect the heater to the mains if there is a risk of frost, since the transformer will use energy unnecessarily otherwise

Maintenance and cleaning

CAUTION!
Risk of physical injury to people and animals and material damage
• Only perform maintenance and cleaning work when the mains plug is disconnected.
When carrying out cleaning and maintenance work, note the following instructions:
• Transformer and cables free from dust and soiling.
• Only clean heating parts with a soft cloth or damp towel. The cloth or towel should be free of petrol and / or other solvents, since these can attack or damage the heating parts.
• Never immerse the heating parts in water or clean them with a water jet.
Technical data
Article number / type designation:
Voltage:
Output:
CE-/UKCA-conformity declaration
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements and other relevant
stipulations and regulations. The CE-/UCKA-mark confirms compliance with the Directives of the European Union or the releant UK legislation.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations. The device must not be disposed of in
household waste. In accordance with the stipulations of the EU Directive on the Disposal of Electrical and Electronic Devices, the device can be disposed of free of charge
at the local waste collection or recycling centre. Alternatively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure environ-
mental protection and prevents any adverse effects on human health and the environment.
82844
Input: 230 V AC, 50 Hz 0.39 A
Output: 24 V DC, 3.7 A
89VA (W)
Protection class: II
Safety class: IP 64
Dimensions: 146 x 74 x 82 cm
Weight: 50.5 kg
4