Ecoflam MAX P 15 AB LN CONFORT 100 Bedienungsanleitung Seite 14

EN
Start up
- Setting data table - Air regulation
The burner leaves the factory with the following calibration values:
BURNER
CODE
3147867 CONFORT 100
3147824 SP 110
3147861 SP 235
The settings above are basic settings. In case of operation at 60 Hz, the burner must be recalibrated by closing the air shutter so as to
reduce the amount of incoming air.
1
B
A
A
!
Risk of air blast!
Continuously check CO, CO 2 and soot emissions when adjusting the output of
the burner. Optimise combustion values in the event of CO formation. CO must
not exceed 50 ppm.
14 www.ecoflam-burners.com
NOZZLE
gph Type spry
1,5 DELAVAN 60°W
1,75 DELAVAN 60°W
3,5 DELAVAN 60°W
2
PUMP BURNER
PRESSURE OUTPUT
bar kg/h
11 - 13 6,32
11 - 14 7,53
10 - 15,5 15,5
FIRING HEAD AIR DAMPER
SETTING SETTING
Pos.A I°
39,5 1,9
39,5 2,2
29,5 2
Low Flame air adjustment (1)
Intervene on screw A in the picture:
• turning it anti-clockwise increases the
flow rate;
• turning it clockwise decreases the
flow rate.
High Flame air adjustment (1)
Intervene on screw B in the picture:
• turning it anti-clockwise increases the
flow rate;
• turning it anti-clockwise decreases the
flow rate.
Firing head setting (2).
Intervene on the screw shown in the
picture:
• turn it using a hex spanner until it
reaches the desired value (index from 0 to
5).
420011136900
II°
3
3,5
3