Oxford HotGrips OF693 Original Bedienungsanleitung Seite 2

Oxford HotGrips™: Fitting and User Instructions for part codes OF693 and OF696
with v.7 heat controllers.
A: Safety fi rst: read carefully before fi tting or using!
IMPORTANT: If you have any doubt about fi tting your Oxford HotGrips™, immediately consult your local
authorised Oxford stockist for advice or alternatively visit our website www.oxprod.com and read the
Frequently Asked Questions.
WARNINGS:
i. Your HotGrips must only be connected and turned on when fi tted to your handlebars as per the
instructions.
ii. Before using the motorcycle/vehicle each time, please ensure that the fi tted HotGrips are fi rmly glued
to the handlebar. Failure to do so could result in an accident or personal injury.
iii. Ensure that the throttle operates freely. Ensure that normal operation of the motorcycle is not
affected. The Hotgrip cables must not foul or restrict the operation of the brake or clutch levers.
iv. HOTGRIPS are designed for use with gloved hands. Do not allow bare skin to come into contact with
your HotGrips when turned "on". Check the temperature for suitability before you set off. If the
temperature becomes too hot when on the move, pull over safely and turn the temperature down or
OFF as appropriate.
v. Do not leave the motorcycle unattended when the HotGrips are turned on. The heat regulation
is only controlled by the motorcyclist turning the heat controller up or down to suit the ambient
weather conditions.
If the grips are left turned ON at a high heat setting whilst the motorbike is in a warm garage or in
warm ambient conditions, damage to the HotGrips or motorcycle could occur. Similarly if the Hotgrips
are left turned on when fi tted inside handlebar muffs the temperatures may rise beyond a safe point
and damage or even risk of fi re could occur in the most extreme situations.
These are designed to be used in cold weather with the rider present.
vi. Replace the HotGrips when the pattern of the outer rubber wears away in any one area.
vii. Regularly check the integrity of the attachment and materials of your HotGrips.
Do not use if in doubt and consult your local authorised OXFORD stockist.
viii. OXFORD Products will accept no liability for the consequences of grips, which have not been securely
fi tted. Liability is limited to the replacement parts of the HotGrips in case of faulty materials or
manufacture.
B: Parts list for product: OF693 and OF696
Before fi tting, check that the following parts are included in the kit:
• 1 x Left HotGrip (22mm I/D x 125mm long )
• 1 x Right HotGrip (25.6mm I/D x 125mm long)
• 1 x Electronic Heat Controller (code OF696HS v7) and adhesive pad
• 1 x Universal bracket for switch - OF91
• 1 x Wiring loom, cable ties and grip glue
1
(fi tment may not be suitable for all vehicles)
Oxford Hotgrips instructions v.7 switch - 10/12/08