THORENS TD 1500 Bedienungsanleitung Seite 36

10. Then move the weight for the anti-skat-
ing in the slot between the tonearm base
at the back and the arm support at the
front to the same value. On the scale, the
long lines, seen from behind, indicate an
increase of 0.5. To adjust the value, it is
best to use a small screwdriver or the pin
supplied with the tone arm height adjust-
ment.
Important: the basic position at the base of the arm specifies the value 0.5, i.e. the other values are based
on this.
Please carry out all these steps very carefully so as not to damage the delicate needle!
36 TONEARM AND CARTRIDGE SYSTEM
Fig. 7 Fig. 8