Operation; Technical Data - IFM Electronic ecomot200 DY 340 Betriebsanleitung

3. Select the display and reset mode from the following table and set the parameter
P09 to the corresponding value.
display mode
Real
(current counting is displayed).
Memory
(only the end result is displayed, it
remains displayed until the next end
result or reset pulse).
Real
(current counting is displayed).
Memory
(only the end result is displayed, it
remains displayed until the next end
result or reset pulse).

9. Operation

After mounting, wiring and programming check the safe functioning of the unit. In
case of correct use no maintenance measures are necessary.

10. Technical data

Nominal voltage AC
Nominal voltage DC
Power consumption
Current consumption
Protection housing front
Operating temperature
Dimensions
Control panel cutout
Inputs
Input frequency
Auxiliary voltage
Switching utputs
Analog outputs (optional)
Accuracy
(with each start signal
the counter starts at 0).
(with each start signal
the counter starts at 0).
[V]
[V]
[VA]
[mA]
[°C]
[mm]
[mm]
[Hz]
[V] 24V, 60mA / 5V, 150mA / 12V, 150mA
reset mode
External
External
AUTO
AUTO
115 / 230
24
4
200
IP 44
0 ... +45
96 x 48 x 150
91 x 43
4 x npn, pnp, NAMUR; HTL or TTL
0.03 ... 25 000
3 x pnp, 5 ... 30V DC, 50mA
short circuit protected
0/4 ... 20 mA; 0 ... 10 V
± 1 digit
value for P09
0
1
2
3
page 29