Connection Of Sensors; Programming - IFM Electronic ecomot200 DY 340 Betriebsanleitung

Connection of sensors:

3-wire DC
If NAMUR pulse pick-ups are used in Ex areas, a suitable separating amplifier must
be connected between the NAMUR pulse pick-up and DY 340.
To guarantee safe functioning, signal cables and load cables should be laid sepa-
rately. Use screened cable if necessary.

5. Programming

Changeover to the
1
programming mode
Selection
of the
2
parameter to
be changed
Setting of the
3
parameter value
If no button is pressed any more, the unit will return to the operating mode after 10s. The changed
*Setting: incremental by pressing briefly or scrolling by holding pressed.
Quick run: holding the
**Active termination of the programming mode: Select parameter P85, enter value 1 and
acknowledge with the
Locking/unlocking
The unit can be locked to prevent unwanted adjustment of the set parameters.
Select parameter P00, enter value 1 and acknowledge with the
For unlocking:
- Press the button for a short time.
P
- Now press the
NAMUR pulse pick-up
5
1 3
6
A
7
B
P
Press the button for a short time.
Press the
Press the
Press the
Press the
parameter values will become active.**
P
or and buttons pressed.
button.
, and buttons one after the other within 5s.
P
2-wire DC /
1 3
6
A
7
B
or button until the requested parameter is shown
in the display.*
button. The current parameter value is shown
in the display.
or button until the requested parameter value
is shown in the display. *
button. The next parameter is shown in the display.
Continue with step 2.
will be shown in the display.
encoder
5
3
6 A
7 B
is shown in the display.
button.
page 19