Repairing The Board; Maintaining The Air Pump; Disposal; Service - Mistral HG06954 Montage-, Bedienungs- Und Sicherheitshinweise

Insert a new valve
best seal, we recommend applying a small
amount of silicone grease or petroleum jelly
around the valve
1a
Place the valve wrench
and tighten, turning clockwise.
Note: If the valve
the valve wrench
11
remove the top of the valve
wrench . Remove any dirt from the valve
11
membrane. Verify the valve
screwing it in.

Repairing the board

Before using the product on water
after making repairs, verify the repair
patch is air tight and seals properly.
7
Never attempt to repair large damaged
areas yourself. Take the product to a
speciality shop.
Detecting holes:
Coat the area on the board
has a hole with soapy water. Bubbles will form
where air is escaping the board
Mark the respective area.
Rinse the board
1
dry before starting the repair.
Patching holes:
Only repair holes with suitable glue. Glue
included. Using the wrong adhesive for repairs
can cause further damage. You can also purchase
suitable adhesive from speciality retailers.
Once you have located the hole(s), release all
of the air from the board
Thoroughly clean the area to be repaired.
Dry the cleaned area.
Measure and cut a repair patch
to cover 1.5 cm around the damaged area.
Note: If you're able to, ensure the surface
around the damaged area and the repair
patch is absolutely free from grease.
7
Apply an even coat of glue
around the damaged area and the actual repair
patch .
7
16 GB
in the valve seat. For the
1a
.
over the valve
11 1a
leaks and tightening with
1a
does not help, completely
with the valve
1a
is tight after
1a
you suspect
1
.
1
with clear water and wipe
.
1
large enough
7
to the surface
6
Allow the glue to dry for approx. 3–4 minutes
(at temperatures of about 20–25 °C).
Place the repair patch
board with the adhesive surfaces facing.
Press the repair patch
with a heavy object.
Note: Be sure to work on an even surface
without kinks or creases. Use a rounded object
to carefully smooth out any bubbles, working
from the middle outward.
Allow the glue to dry for at least 12 hours.
Once dry, apply more adhesive along the edge
of the repair patch
dry for approx. 4 hours along this seam.

Maintaining the air pump

Ensure the air pump
and after use.
To grease the air pump
the top and apply a thin coat of oil or grease
to the sealed areas and lines. Be sure to use
acid-free silicone oil.

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
is
6
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.

Service

Service Great Britain
Tel.: 08000569216
E-Mail: owim@lidl.co.uk
on the surface of the
7
onto the board
7 1
. The glue only needs to
7
is greased well before
13
, open the cap at
13