Installing The Us Fin; Assembling The Single Blade Paddle; Assembling The Double-Bladed Paddle; Disassembling The Product - Mistral HG06954 Montage-, Bedienungs- Und Sicherheitshinweise

Installing the US fin (Fig. E)
Insert the metal plate
dle of the slot and slide forward.
Note: You can use the screw
plate along the slot.
Insert the back of the US fin
and slide back. Insert the front of the US fin
in the fin box and slide the US fin
until the hole in the fin is located over the hole
in the metal plate
12a
Insert the screw
12b
screw it in along with the metal plate
secure the US fin
12
Note: Always ensure the fins are facing toward
you when carrying the board
careful not to injure others with the board
windy conditions.
Assembling the single blade
paddle (Fig. K)
Loosen the locking lever
Insert the paddle shaft
Extend the paddle shaft
length.
Note: For information about the recommended
paddle length, please see chapter "Adjusting
the paddle length".
Press in the locking lever
to lock the paddle shaft
Insert the paddle blade
the extension . Ensure the locking pin is in-
4
serted all the way in the pinhole on the paddle
blade . You must hear the pin on the exten-
2a
sion click into place when it locks into the
4
pinhole of the paddle blade
Assembling the double-bladed
paddle (Fig. K)
Loosen the locking lever
Insert the second paddle blade
of the extension
4
12 GB
in the hole in the mid-
12a
to slide the
12b
in the fin box
12
forward
12
.
in the hole in the fin and
to
12a
.
. Be particularly
1
1
on the extension
4a
in the extension
3
to the desired
3
on the extension
4a
.
3
in the opening on
2a
.
2a
on the extension
4a
in the end
2b
with the locking lever
4a
Turn the second paddle blade
sired angle.
Push in the locking lever
to lock the second paddle blade
Insert the paddle blade
the extension
serted all the way in the pinhole. You must hear
the pin on the extension
12
when it locks into the pinhole.

Disassembling the product

Select a clean, even surface with adequate
space to disassemble the product.
Disassembly requires the following steps:
in · Removing the US fin
ries (foot rest
· Releasing air from the board
· Rolling up the board
· Disassembling the paddle into the individual
parts
Note: Remove the US fin
. air from the board
4
.
4
Removing the US fin:
Remove the US fin
the US fin" in reverse order.
Disassembling the paddle:
Disassemble the paddle per chapter "Assem-
4
bling the single blade paddle" or "Assembling
the double-bladed paddle" in reverse order.
Releasing air:
Place the dry board
open the two valves
needle whilst turning clockwise.
1b
Only push the valve needle
can escape slowly.
Release the air.
You can alternatively use the air pump
fold the board
. ing the hose
4
(Deflate). Connect the hose
. valves . The valve head must be down. Turn
1a
the valve head to the right (Fig. C4), pump and
to the de-
2b
on the extension
4a
2b
in the opening on
2a
. Ensure the locking pin in in-
4
click into place
4
and other accesso-
12
, seat )
18 16
1
1
before releasing
12
.
1
per chapter "Installing
12
flat on the ground and
1
by pushing in the valve
1a
in slightly so air
1b
as flat as possible by attach-
1
backwards on the air pump
14
to one of the
14
4
in place.
to
13
13