Using The Product; Adjusting The Paddle Length; Using On The Water - Mistral HG06954 Montage-, Bedienungs- Und Sicherheitshinweise

extract the remaining air from the board
until it is completely flat.
Then turn the valve head anti-clockwise so it
comes out upward (Fig. C1).
Now place the board
(Fig. N1).
Then fold the board
nose over the tail (Fig. N2).
Then fold the tail and nose again, making sure
the external fins under the board
buckle (Fig. N3).
Do not fold the board
outside edges of the fin box. This will
cause excessive tension in the board
Now fold the opposite side to about the middle
(Fig. N4).
Then fold the board
opposite side so the external fins are on top
(Fig. N5).
Use the strap to lash up the board
Attach the fin protector
remain straight whilst packed.

Using the product

Adjusting the paddle length

Stand straight and raise one arm up; bend
your palm to about a right angle (Fig. J).
Open the locking lever
slide the extension up until the paddle handle
fits below your bent palm. Close the lock on
the locking lever
4a
the correct length.
Important: Do not extend the paddle
shaft past the "STOP" mark. The
3
paddle will otherwise become unsta-
ble and could break.

Using on the water

Note: Be careful not to hurt others when carrying
the board in windy conditions. Always keep the
1
fins toward you.
1
flat on the ground
1
once and place the
1
do not
1
along the
1
once more onto the
1
.
1
to the fins so they
15
on your paddle and
4a
. Your paddle is now set to
Note: You can use the board
sitting.
Standing up:
In this position, use the leash
tional safety measure.
Do not attach the leash
using the board
with rapids such as streams and rivers.
Always attach the leash
offshore winds.
If you find yourself in distress, always stay on
the board
1
. in strong offshore winds, or you may drown. In
1
this case, use the international distress signal to
draw attention to yourself: stand or sit on the
board and slowly and clearly raise and
1
lower your straight arms at your side (Fig. P).
Attach the leash
1. Attach the leash
2. Pull the loop on the leash
D-ring
.
1c
3. Pull the leash strap
the leash
4. When standing to use the board
deeper waters, attach the leash
leg / ankle (Fig. H / I).
Seated:
To use the board
need to install the foot rest
(Fig. O). Proceed as follows:
Installing the foot rest
Insert the tube end of the foot rest
the first loop
Insert the opposite end through the second
loop until both are in the middle of the
19
board .
1
Installing the seat
Place the seat
legs are slightly bent when your heels are
touching the foot rest
standing up or
1
as an addi-
9
to your ankle when
9
on flowing water, e.g. water
1
to your ankle in
9
. Never abandon the board
as shown in figure G:
9
to the rear D-ring
9
through the
9b
through the loop on
9a
.
9b
9
in a seated position, you will
1
and the seat
18
:
18
18
from the side.
19
:
16
on the board so your
16 1
.
18
1
.
1c
in
1
to the
16
through
GB 13