ABL Wallbox eMH2 Kurzanleitung Und Sicherheitshinweise Seite 14

14 |
Wallbox eMH2 – Charging procedure
7
Observe the LED indicators and acoustic
signals of the wall box.
y While checking whether the RFID card is
enabled is in process:
» The green LED will illuminate.
» The blue LED will pulsate.
» A short acoustic signal will sound.
y If the RFID card is enabled:
» The green LED will go out.
» The blue LED will pulsate.
» The short acoustic signal will sound
twice.
If the RFID card is rejected, the red LED will flash and a long acoustic signal will sound. In this
case, you should get in contact with the issuer of your RFID card or ensure that the RFID card is
trained to the RFID reader.
8
Observe the LED indicators on the wall box:
y If the wall box is started after prompting by
the vehicle, the blue LED will flash.
y When the charging procedure is paused or
completed, the blue LED will pulsate.
The charging procedure can be paused by the vehicle. Otherwise the charging procedure will
be automatically ended by the vehicle after completion. It is only possible to differentiate by
means of the indicators in the vehicle.
9
Remove the charging coupler from the charg-
ing port of the electric vehicle and close it.
10
Store the charging cable for the next charging
procedure.
y Cable version type 2
Store the charging coupler in the coupler
pocket.
y Socket version type 2
Remove the charging plug from the charg-
ing socket and store the charging cable:
The charging flap is automatically closed.