Cleaning And Maintenance - cecotec Juice&Live 3000 EasyClean Bedienungsanleitung

ENGLISH

6. CLEANING AND MAINTENANCE

• Before cleaning the product, close the juice and pulp outlet lids, pour some water inside
the machine and operate it for a few seconds. Then, empty water out.
• Long press the reverse function button for the screw to rotate in opposite direction. This
way, blocked rests of food will be removed.
• Disconnect the product from the power supply before cleaning the product's surface. Use a
soft, dry cloth to clean it. The rest of the parts can be washed with water o in the dishwasher.
• Clean the juicer immediately after each use. Dot not immerse the product's main body or
power cord in water or other liquids.
• Do not wash the detachable parts with water over 60 ºC. Use warm water with some
soap and easily clean these parts. Then, rinse with water. It can also be washed in the
dishwasher.
• After cleaning the device, make sure you dry it thoroughly before storing it.
• After using the product, store it in a dry, safe place. Avoid direct exposure to sun light.
• Make sure it is stored in a place out of the reach of children.
TO DISASSEMBLE DE DEVICE IN ORDER TO CLEAN EACH OF ITS PARTS:
• Rotate the food inlet tube anticlockwise to the unlock position, and pull upward from it to
remove it from the rest of the appliance.
• Pull from the screw to remove it. In case it is hard to remove it, remove it together with
the screw support.
• Take out the filter (if it has not been removed earlier).
• Wash all of the parts with water and cleaning agent, and dry them thoroughly before
reinstalling them in the device.
7. TROUBLESHOOTING
PROBLEM
The device doesn't work when
connected to the power supply
and pressing the power button.
40 JUICE&LIVE 3000 EASYCLEAN
04135_Juice&Live 3000 EasyClean.indd 40
CAUSE
• Power plug not inserted properly.
• The device has been operated for
too long and has activated safety
system.
• Components are not installed
correctly.
SOLUTION
• Connect the machine to
the power supply.
• Allow the machine to rest
and restart it after 20 min.
• Install all the components
correctly.
1/10/19 12:26