Prior To Initial Use; How To Operate Your Appliance Switching On; Grilling And Raclette - Rommelsbacher Rcc 1000 Bedienungsanleitung

must have cooled completely before cleaning or moving them!
• Observe the following when setting up the appliance:
- Place the appliance on a heat-resistant, stable and even surface (no
varnished surfaces, no tablecloths etc.).
- Place it beyond children's reach.
- Leave a ventilation distance of at least 20 cm to all sides and 1 m
above the appliance to avoid damage by heat or fat splatters and
to grant an unobstructed work area. Unhindered air supply has to
be ensured.
- Do not operate the appliance in the vicinity of sources of heat (oven,
gas fl ame etc.) or in explosive environments, where infl ammable
liquids or gases are located. liquids or gases are located.
Attention! Hazard of fi re! This appliance is not qualifi ed for installation.
• Pull the power plug after each use for safe switch-off.
• Do not use the appliance as room heater.
Prior to initial use
Wipe the casing with a damp cloth and dry it thoroughly.
Clean the pans, the spatulas and the grill plate with hot water prior to initial use.
Prior to initial use, the protective coating of the heating elements has to be burnt in.
Heat up the appliance – without pans! – for approx. 10 minutes with maximum power. Please do not be
bothered by the slight, harmless smoke and smell, which will appear for a short while.
How to operate your appliance
1. Switching on
• Position the grill plate correctly on the frame and place the pans on the practical parking surface.
• Then connect the mains plug to a suitable socket. The appliance is heating now. All LEDs light up and
show that the appliance is ready for use. The diodes are glowing as long as the appliance is switched on,
independent of the selected temperature.
• Now turn the temperature regulator clockwise to MAX and pre-heat for 10 minutes.
Warning: The grill plate becomes hot during use. Therefore, be aware of the hazard of burns when
touching!
2. Grilling and raclette
• After heating up the appliance, slide in the fi lled pans just up to the set stop (cavity in the raclette level).
CAUTION, HOT! When inserting the pans mind not to touch the hot edge of the grill plate!
• The temperature can be infi nitely adjusted according to requirements.
• By means of the spatulas, the food in the pans can be moved or the cheese can be pushed out. You can
also use other utensils made of wood or plastic. However, make sure that they do not have longer
contact with hot parts. Do not at all use cutlery made of metal as otherwise the non-stick coating may be
damaged.
• Never heat up empty pans and never put empty pans in the hot Raclette level as overheating might cause
damage to the non-stick coating.
• Note: Always park the pans not in use on the practical parking surface when taking breaks from eating.
This ensures a gentle treatment of the non-stick coating.
• Warning: Do not cut or scratch on the grill plate and in the pans. Scratched or superheated pans or grill
plates are not covered by warranty.
14