Razor Siege Caster Scooter Gebrauchsanweisung Seite 4

SET UP aND USagE INSTRUCTIONS
Installing the Handlebars
1
Insert and secure the left and
right handlebars by pressing the
spring-loaded buttons and
inserting them into the T-bar.
Folding/Unfolding the Scooter
A B
1
To release the folding mecha-
nism, hold the T-bar with one hand
between the collar clamp and the
quick-release lever and place one
foot on the deck plate. Pull lever (A)
on folding mechanism outward. Then
pull up on the red release lever (B)
and pull handlebars upward until
steering tube is locked into place.
Move folding mechanism lever
inward to lock in place.
adjusting the Handlebar Height
1
To adjust the height of the
handlebars, unlock the extension
tube by pulling outward on the
quick-release lever and pushing the
button located on the extension
tube. Slide the T-bar to the desired
height and secure by pushing
inward on the quick release lever.
2
Make certain the spring-loaded
button engages the hole in the
T-bar for each handlebar.
2
The Joint lever is spring-loaded
and will automatically lock in the
upright position when fully upright.
2
The tension of the quick-release
lever can be adjusted by tightening
or loosening the allen bolt. Be care-
ful not to over-tighten. You should
be able to open and close the quick-
release lever by hand.
Note: If tension on folding
mechanism lever (A) is too tight/too
loose, carefully twist the black knob
located on the opposite side of the
lever (A) to tighten/loosen the ten-
sion so you can secure the steering
tube in place.
3
WaRNINg: Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-bar.
WaRNINg: Keep
your fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
WaRNINg: Failure to
properly secure the quick-release
lever may cause the T-bar to slide
up or down while riding which
may cause you to lose control
and fall. With the quick-release
properly adjusted and secure, the
handlebars will not move up or
down.