Introduction; Conventions; Important Notes; General - Mettler Toledo InFlow 751 Bedienungsanleitung

4
1
1.1
2
2.1
2.2
Retractable Housing InFlow 751
52 400 740 E

Introduction

These operating instructions describe how to use the housings InFlow
These housings are state of the art, high-grade engineered products, tested by METTLER TOLEDO.
Nevertheless, improper handling could be dangerous.

Conventions

This pictogram represents safety and hazard warnings which, if ignored could result in injuries
to personnel and/or in material damage.

Important Notes

General

Immediately on receipt, check that the housing is complete and in good condition. Notify your
supplier of any damage or deficiency. Please also refer to your supplier for further information on
the ordering of spare parts and accessories.

Safety Precautions

Safety and hazard warnings could, if ignored, result in injuries to personnel and/or material damage.
Important! Work on the housing should be assigned only to trained personnel.
• Observe local regulations concerning the safety of people and property.
• Be sure to read and follow the instructions in this operating leaflet carefully.
• The InFlow 751 housings are designed to contain only METTLER TOLEDO sensors. Any other
kind of use could be dangerous and is not permitted.
• The materials used for the housing are described in Section 3 "Description of Product and
Materials". Make sure the materials are suitable for the required application.
• To ensure that the housing is correctly installed and maintained, follow the instructions given
in this leaflet.
• Incorrect handling of the housing can result in a broken sensor and leakage from the vessel.
• Before doing anything to the installed housing, ensure that the process facility is in a safe
condition (release pressure, empty, rinse, vent, purge, etc.).
• Use only clean sensors, housings and sockets. Replace any damaged seals and housing
components immediately.
• Before starting up, always check the measuring system. Inspect the housing/sensor assembly
and check for leaks from housing and apparatus.
• If ever in doubt, consult your supplier.
InFlow 751
751.
®
© 06/2021 METTLER TOLEDO
Printed in Switzerland