Instructions For The Brushless Speed Controller (Esc) - Carson X-18 Betriebsanleitung

Functions
∆ Forward: Pull the throttle lever on the radio, the car goes forward.
∆ Brake: Push the throttle lever to brake the car.
∆ Reverse: Push the throttle lever forward, when the car is not run-
ning. Then the car will run backward. Speed can be proportionally
controlled.
GB
d. Instructions for the Brushless Speed Controller (ESC)
5004040247
Features
• Running modes: Forward mode and forward/backward mode.
• Proportional ABS brake function, with 4 steps of maximum brake
force adjustment, 8 steps of drag-brake force adjustment.
Adjustments
1. Connect the ESC, motor, receiver, battery
and servo according to the following
diagram.
Positive (+) and negative (-) wires of the ESC are connected with the
battery pack. A, B and C are connected with the motor wires. The
control cable of the ESC (wires in black, red and white colour) is
connected with the throttle channel of the receiver (usually CH2).
The A, B, C wires of the ESC can be connected with the motor wires
freely (without any order). If the motor runs in the opposite direction,
please swap any two wire connections.
The "SET" button is used for programming the ESC.
2. Throttle range setting
(throttle range calibration)
In order to make the ESC fit the throttle range of your
transmitter, you must calibrate it for the following cases;
otherwise the ESC cannot work properly.
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the throttle lever, the
ATV or EPA parameters, etc.
24 CARSON X-18 Chassis 500404046 + 500404047
Warning:
∆ This ESC is not waterproof. Water should be avoided. lf water goes
into it, take down the power switch immediately.
∆ It's dangerous to touch the motor after running, as it emits heat
during running, and the cooling plate is hot after running.
• Different options of start modes (also called "punch") from "soft" to
"aggressive".
• Splash proof and dustproof
the
e
Steering
Servo
).
res
ction,
SET Button
Receiver
A, B, C
ON
motor wires
Input TH
OFF
channel
(CH2)
Switch
he
Red power wire
(battery positive)
Black power wire
(battery negative)
Brushless motor