Weidmuller UHZ/AR Bedienungsanleitung Seite 25

Connections(continued)
All manuals and user guides at all-guides.com
7
Link to change the set-up
8
9 Neutral (−)
10 Live (+)
11 Channel one
12 Channel two
13 Common
14 Output +
15 Current −
16 Voltage −
Case Earthing is via a stud on lower side of case
PowerSupplyRequirements
Check the power supply against the model number before applying
power to the instrument. Micromann modules must be used with a
suitable mains Power Supply, ratings are as follows:
Voltage Range
100–132 V AC
200–264 V AC
12–50 V DC*
*Using a DC power supply that provides this voltage will comply with
the instrument's UL/CSA listing.
•Calibration
General
The UHZ/AR is factory calibrated and will operate with any input or
output format without recalibration.
During calibration allow a few seconds for signals to stabilise before
accepting the value.
Nominal Voltage
110 V AC
240 V AC
24 V DC
Security Link
Power supply
Alarm outputs
Analogue outputs
Power
6 VA
6 VA
6 W (at 24 V DC)
Frequency
47-63 Hz
47-63 Hz
-
21