Start-Up And Use; Starting The Dishwasher; Measuring Out The Detergent - Indesit dfp 573 Gebrauchsanleitung

Start-up and use

Starting the dishwasher

EN
1. Turn the water tap on.
2. Press the ON/OFF button: all the indicator lights on
the control panel will light up for a few seconds.
3. Open the door and pour in a suitable amount of
detergent (see below).
4. Load the racks (see Loading the racks) and shut the
door.
5. Select the wash cycle in accordance with the type
of crockery and its soil level (see Table of wash
cycles) by pressing the P button.
6. Select the wash options* (see adjacent
information).
7. Start the cycle by pressing the Start/Pause button
(fixed light). A long beep signals the start of the wash
cycle; the wash cycle indicator light is illuminated and
the time remaining until the end of the cycle is
displayed.
8. Two short beeps and one long one indicate the end
of the wash cycle; the Start/Pause button switches off
and the word END appears on the display. Switch off
the appliance by pressing the ON/OFF button, shut off
the water valve and unplug the appliance from the
electricity socket.
9. Wait for a few minutes before removing the
crockery, in order to avoid burns. Unload the racks,
beginning with the lower level.
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided that
it has only just begun: once the wash cycle has started,
switch off the machine by pressing and holding the ON/
OFF/Reset button. Switch it back on using the same
button and select the desired wash cycle and options.
Press the Start/Pause button (the corresponding
indicator light will flash). Open the door, taking care to
avoid the escaping steam, and place the crockery inside
the appliance. Press the Start/Pause button (fixed light):
the cycle starts from the point at which it was interrupted.
If the Start/Pause button is pressed so as to pause the
machine, the wash cycle or the Delayed Start
(if selected) is interrupted.
At this stage it is not possible to change the wash cycle.
If the door is opened during the wash cycle, or if there is
a power cut, the cycle stops. It starts again from the point
at which it was interrupted once the door has been shut
or once the electricity supply is restored.
6

Measuring out the detergent

A good wash result also depends on the correct
amount of detergent being used; exceeding the stated
amount does not result in a more effective wash and
increases environmental pollution.

To achieve the best results from each washing
and drying cycle, powder detergent, rinse aid liquid
and salt should be used.
Compartment A: Washing detergent
Compartment B: Pre-wash detergent
D
A
when the cycle requires 1 tablet, place it in compartment
A and close the cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
*
function
*
1. Open cover C by pressing
B
button D.
2. Pour in the detergent after
consulting the Table of wash
cycles:
• For powder detergent use
compartments A and B.
• For detergent in tablet form:
C