1
Product description
EN
1.3
Basic requirements for safe working practices
Electrical safety
Do not operate the charger if the housing, power cable or plug are damaged.
Do not use batteries which have been damaged or modified in any way. Batteries which have been
damaged or modified may respond unpredictably, causing fire, explosion or injury.
Do not open the charger.
Do not modify the charger structurally.
Operate the charger in dry, enclosed rooms only.
Protect the charger from moisture and rain.
Never operate the charger under unsuitable ambient conditions (i.e. where combustible gases, sol-
vents, dust, vapors or moisture is present).
Use the power cables supplied for use in the EU, NA (North America) and GB (Great Britain).
Outside these regions, use a suitable power adapter.
Workstation
Ensure that there is enough space at the workstation.
Keep the work area clean and dry.
1.4
Designated use
The charger is intended exclusively for charging the following Cleco Production Tools batteries
Order no. 935377 (26 V, Li-Ion)
1.5
Items supplied
Check shipment for transit damage and ensure that all items have been supplied:
1
1
1
2
Product description
2.1
General description
•
Automatic identification of a defective battery.
•
The recharging phase guarantees maximum run time of the battery.
•
Charge status display
•
Overcharge protection
•
Wide-range input make worldwide use possible.
•
Voltage monitor prevents deep discharging and battery short-circuits.
4
Battery charger
1
EU power cable
1
NA power cable
Order no. 961101PT (26 V, Li-Ion HC)
GB power cable
Instruction Manual
P1893BA | 2019-01
Apex Tool Group GmbH