Safety Instructions For All Operations - Worx makerX WX741 Originalbetriebsanleitung

other battery packs may create a risk of injury and fire.
c) When battery pack is not in use, keep it away from other metal objects, like
paper clips, coins, keys, nails, screws or other small metal objects, that
can make a connection from one terminal to another. Shorting the battery
terminals together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with water. If liquid contacts
eyes, additionally seek medical help. Liquid ejected from the battery may
cause irritation or burns.
6) Service
a) Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power tool
is maintained.

SAFETY INSTRUCTIONS FOR ALL OPERATIONS:

Safety warnings common for grinding, sanding or abrasive cutting-off opera-
tions:
a) This power tool is intended to function as a grinder, sander or cut-off tool.
Read all safety warnings, instructions, illustrations and specifications
provided with this power tool. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious injury.
b) Operations such as wire brushing or polishing are not recommended to be
performed with this power tool. Operations for which the power tool was not
designed may create a hazard and cause personal injury.
c) Do not use accessories which are not specifically designed and
recommended by the tool manufacturer. Just because the accessory can be
attached to your power tool, it does not assure safe operation.
d) The rated speed of the accessory must be at least equal to the maximum speed
marked on the power tool. Accessories running faster than their RATED SPEED
can break and fly apart.
e) The outside diameter and the thickness of your accessory must be within the
capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately controlled.
f) Threaded mounting of accessories must match the GRINDER spindle thread.
For accessories mounted by FLANGES, the arbour hole of the accessory must
fit the locating diameter of the FLANGE. Accessories that do not match the
mounting hardware of the power tool will run out of balance, vibrate excessively
and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the accessory
such as abrasive wheels for chips and cracks, backing pad for cracks, tear
or excess wear. If power tool or accessory is dropped, inspect for damage
or install an undamaged accessory. After inspecting and installing an
accessory, position yourself and bystanders away from the plane of the
EN
9