Installation - EUROM Partytent Heater Sail Bedienungsanleitung

Hanging on a frame
1. Place the additional hanging chain (30 cm)
(Figure 8, pos. 2) through the ring of the
hanging chain (50 cm) (Figure 8, pos. 3) and
over the frame (Figure 8, pos. 4).
2. Attach a karabiner hook (Figure 8, pos. 1) to
both ends of the additional hanging chain (30
cm) to close the loop.
3. Attach a karabiner hook (Figure 7, pos. 4) to
the hanging chain (Figure 7, pos. 3) and the
hanging eye of the device (Figure 7, pos. 5).

Installation

WARNING
Do not put the power plug into the wall socket before the device is correctly
mounted in the right place.
Do not use an extension cable, this can cause overheating and fire. If using an
extension cable is unavoidable, make sure it is undamaged and earthed. Use
an extension cable with a minimum power of 1500 Watt. Always unwind the
extension cable completely to prevent overheating.
CAUTION
Make sure that the main voltage is the same as indicated on the identification
label of the device. All electrical connections must stay dry under all
circumstances.
1. Make sure the device is firmly mounted.
2. Place the power cable (Figure 9, pos.2) along
the hanging chain using tie wraps (Figure 9,
pos. 3).
3. Place the power plug (Figure 9, pos. 1) into an
earthed wall socket that is easily accessible.
Use an earthed wall socket with a minimum
power of 1500 Watt.
4. Make sure the power cable does not come
into contact with the device.
Figure 8
Figure 9
17