Primary Air; Secondary Air - Supra GOTEBORG Installations- Und Bedienungshandbuch

SWITCHING THE FLUE CONNECTION
The stove is supplied with the flue collar mounted on the top.
Depending on the flue type, the collar can also be installed on the
rear outlet of the appliance. To switch the flue orientation:
Lift up and remove the upper part of the stove.
Remove the exterior cover (2 screws).
Remove the 2 screws securing the collar and the 2 screws
securing the interior cover.
Check the position of the seals and switch the position of the collar
and the interior cover. Mount the top of the stove.
Connect the stove.
3. USE
CAUTION:
- This wood burning stove is designed to be used with the door
closed. The door must remain closed except for refuelling.
- To avoid burns, do not touch the appliance and wear insulating gloves
to operate the controls.
- The heat emitted through the vitroceramic glass makes it
necessary to maintain a safety clearance with any material that
could be damaged by the heat (furniture, wallpaper, woodwork,
etc.). A 2 m clearance will avoid any risk.
FUEL
Wood
This high-performance appliance requires good quality fuel. Only
burn air-dried logs (2 to 3 years, stored in a sheltered and well-
ventilated place) with a maximum humidity of 15 to 20%.
Preferably hardwoods (birch, hornbeam, beech, etc.).
Avoid softwoods (lime, chestnut, willow, poplar),
It is strictly forbidden to permanently use resinous wood (pine,
fir...) as well as the use of waste from processed wood (railway
sleepers, woodworking waste, etc.) and household scraps
(vegetables or plastics).
Never use small wood, boxes, woodchips and vine shoots that
could lead to sudden overheating.
CAUTION:
The use of coal or its derivatives is strictly
prohibited, even on an occasional basis. This appliance must
not be used to burn domestic waste.
STOVE CONTROLS
Primary air damper
+ Open (push in)
- Closed (pull out)

PRIMARY AIR

TABLE (*)
Lever primary air
Lighting the fire Push in
Nominal Push in
efficiency
Min. size: Pull out
LIGHTING THE FIRE FOR THE FIRST TIME
- Remove the self-adhesive labels (except for the nameplate),
any possible blocking cards, and make sure that the ash tray is
empty.
- Start with a small fire and gradually increase the load. This
progressive heating allows the materials to expand slowly and to
stabilise. There may be some fumes and odours, due to the
paintwork. These will gradually disappear. Do this for a few days
Secondary air damper
+ Open (push in)
- Closed (pull out)

SECONDARY AIR

STOVE CONTROLS
secondary air
Push in
Push in
Pull out