Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SEALING LEAKS
•
Risk of damage!
•
Not every adhesive is suitable for repairing the board. Repairs with unsuitable glue can lead
to further damage.
•
Only use special glue for inflatable boats. You can obtain such glue from specialist dealers.
•
You can seal holes or cracks with glue and the material patches supplied in the repair kit.
•
Deflate the board before repairing.
Smaller leaks (smaller than 2 mm)
Leaks smaller than 2 mm can be repaired with glue.
1.
thoroughly clean the area to be repaired.
2.
Allow the area to be repaired to dry completely.
3.
Apply a small drop of adhesive to the leak.
4.
allow the adhesive to dry for approx. 12 hours.
Larger leaks (larger than 2 mm)
Leaks larger than 2 mm can be repaired with adhesive and material patches.
1.
Clean the area to be repaired thoroughly and let it dry completely.
2.
Cut out a piece of the material patch that overlaps the leak by approx. 1.5 cm on each side.
3.
Apply glue to the underside of the cut-out patch.
4.
Apply a thin layer of glue to the leak and the surrounding outer skin over the entire size of
the material patch.
5.
Allow the adhesive to set for 2-4 minutes until it is visibly tacky.
6.
Alace the cut-out material patch on the leak and press it firmly.
7.
Allow the adhesive to dry for approx. 12 hours.
8.
To seal the area completely, apply adhesive again to the edges of the material patch after it
has dried.
9.
Allow the adhesive to dry for approx. 4 hours.
Before using the board in the water again, check that the leak is really completely sealed. If bubbling
still occurs, take the board to a specialist workshop for repair or contact the service address given
in these instructions.
Replacing the valve
If the valve needs replacing, you can order a replacement valve from the service address given.
1.
Release the air from the board.
2.
Turn the valve cap anticlockwise and remove it.
3.
Place the valve spanner from the repair kit supplied on the top of the valve and turn it
counterclockwise to loosen it. While doing this, fix the lower part of the valve inside the board
19
Werbung
Inhaltsverzeichnis
