Herunterladen Inhalt Inhalt Diese Seite drucken

YEAZ PARADISE BEACH-EXOTREK Bedienungsanleitung Seite 17

Sup-boards
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
REMOVING THE FIN
Unscrew the screw from the square nut. Slide the fin and then the square nut out of the rail with
the help of the screw. Immediately reattach the screw and square nut to the fin.
RELEASING THE AIR
Gently press the valve insert needle to slowly
release pressure from the board. When the
board's
air
pressure
after about 10 seconds, push the valve needle
completely down and turn it clockwise to lock it in
the „open" position. When releasing the air, please
make sure that no sand or dirt is around the valve
or gets inside.
ATTENTION: Only remove the valve cover to inflate/
deflate the air. This will prevent accidental air
leakage and ingress of any particles into the valve.
Now begin to gently roll the board in from the front towards the valve to release any remaining
air from the board. Replace the valve cap and close it tightly to prevent dirt and moisture from
entering. Now unfold the stand up paddle board again and start rolling it in from the other side
where the valve is located. This way, the board is easier to fold and the fins are better protected at
the same time. Place the foam pads supplied on the fixed fins for protection.
USING THE BOARD
Use the luggage cord to carry and secure extra items on the board.
Use the carry handle if you want to transport the board on land.
Always carry the supplied paddle when using the board.
If your board has capsized and is lying with the top of the board on the surface of the water,
turn it over with both hands so that the top is facing upwards again. If necessary, move to the
shore if you are unable to do so from the water.
CLEANING
Improper or irregular cleaning of the board set may cause damage.
Do not use aggressive cleaning agents, brushes with metal or nylon bristles or sharp or
metallic cleaning objects such as knives, hard spatulas and the like. They can damage the
surfaces.
Do not use solvents to clean the board set.
Clean the board thoroughly after each use.
You can clean the board when it is inflated or when the air is deflated.
1.
Place the board on a smooth, flat and dry surface.
has
dropped
slightly
17

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis