YEAZ PARADISE BEACH-EXOTREK Bedienungsanleitung Seite 15

damage to the board and even bursting of the seams. When used on the water, the heat is
dissipated by direct contact with the water. Transport on a roof rack is also harmless when
the vehicle is moving. The heat is dissipated by the airstream.
• Store the board in the shade when not in use and avoid direct sunlight.
• Reduce the pressure by releasing air.
• Inflate the board again before use according to the general instructions.
ASSEMBLY
Please do not use sharp tools!
UNFOLDING THE BOARD
Find a smooth and clean surface to unfold the tube body.
For initial inflation and to familiarise yourself with your new YEAZ product, we recommend that
you inflate it at room temperature. The PVC material is soft, which makes it easier to assemble. If
the paddleboard has been stored at a temperature below 0°C, store it at 20°C for 12 hours before
unfolding.
OPERATING THE VALVE
To inflate the board, remove the safety cap from
the valve. To do this, turn it counterclockwise. The
valve is opened (when deflating at the bottom) or
closed (when inflating at the top) by a spring-loaded
insert. Before you start inflating, please make sure
that the valve insert needle is in the „up" position.
If the needle is in the „down" position, please press
on the valve core needle and turn it clockwise or
anticlockwise until it pops up.
15