Dimensions / Fastening Dimensions; Mounting / Dismounting, Operating Position - Stahl 9162 Serie Betriebsanleitung

Mounting and installation
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8.1

Dimensions / fastening dimensions

EN
EN
Dimensional drawings (all dimensions in mm [inches]) – Subject to alterations
EN
EN
EN
EN
EN
EN
EN
8.2

Mounting / dismounting, operating position

8.2.1 Mounting / dismounting pac-Bus
The pac-Bus is an accessory which facilitates wiring of the auxiliary power and reading
out of the collective error message.
12
Transmitter Supply Unit with Limit Values
Series 9162
All manuals and user guides at all-guides.com
Explosion hazard due to installation without approved field enclosure!
Non-compliance results in severe or fatal injuries!
• In hazardous areas (Zone 2 or 22), the device must be installed in an
enclosure which fulfils the requirements of IEC/EN 60079-15 or
IEC/EN 60079-31.
Explosion hazard due to incorrect installation of the device!
Non-compliance results in severe or fatal injuries.
• Carry out installation strictly according to the instructions and national
safety and accident prevention regulations to maintain the explosion
protection.
• Select and install the electrical device so that explosion protection is not
affected due to external influences, i.e. pressure conditions, chemical,
mechanical, thermal and electric impact such as vibration, humidity and
corrosion (see IEC/EN 60079-14).
• The device must only be installed by trained qualified personnel who is
familiar with the relevant standards.
X
99 3 90 [ , ]
The components for the pac-Bus Type 9194 must be ordered separately.
DANGER
DANGER
17,6 [0,69]
Screw terminals
Spring clamp
terminals
09685E00
Dimension X
108 mm / 4.25
128 mm / 5.04
240194 / 916260310140
2016-02-12 BA00 III en 01