Symbols On The Device; Symbol Meaning; Safety Notes; Operating Instructions Storage - Stahl 9162 Serie Betriebsanleitung

2.3

Symbols on the device

Symbol Meaning
CE marking according to the current applicable directive.
05594E00
According to marking, electric circuit certified for hazardous areas.
02198E00
Input
15649E00
Output
15648E00
Please refer to this documentation for safety information
3

Safety notes

3.1

Operating instructions storage

• Read the operating instructions carefully.
• Store the operating instructions at the mounting location of the device.
• Observe applicable documents and operating instructions of the devices
to be connected.
3.2

Safe use

Before mounting
• Read and observe the safety notes in these operating instructions!
• Ensure that the contents of these operating instructions are fully understood by the
personnel in charge.
• Use the device in accordance with its intended and approved purpose only.
• Always consult with R. STAHL Schaltgeräte GmbH if using the device under operating
conditions which are not covered by the technical data.
• Observe the document "Cabinet installation guide" for engineering (download from
www.stahl-ex.com, product documentation, subitem "Engineering").
• We cannot be held liable for damage at the device caused by incorrect or unauthorized
use or non-compliance with these operating instructions.
• Install the device in Zones 2, 22 or outside of hazardous areas.
• When used in Zones 2 or 22, the device must be built into an enclosure which
corresponds to the requirements of IEC/EN 60079-15 or IEC/EN 60079-31.
• Any damage may compromise the explosion protection.
240194 / 916260310140
2016-02-12 BA00 III en 01
All manuals and user guides at all-guides.com
Transmitter Supply Unit with Limit Values
Series 9162
Safety notes
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
5