Lacor DUAL Gebrauchs- Und Instandhaltungsanleitung Seite 42

E1 Cause: The device becomes too hot (e.g. due to blocked ventilation slots)
Solution: Clear/unblock ventilation slots. Let the device cool off for a few minutes; the
device is ready for operation afterwards. Contact the retailer in case the
error message remains indicated in the display after the device has cooled
off.
Cause: Parts are damaged (e.g. transistor)
Solution: Contact retailer.
E2 Cause: Overheating-protection was activated and the device switched off.
Solution: Remove the cookware from the hob. Let the device cool off for a few
minutes. The device is ready for operation afterwards.
E3 Cause: Temporary overvoltage, device became too hot.
Solution: Let the device cool off for a few minutes. The devices is ready for
operation afterwards.
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages to the
induction hotplate.
Special Declaration
All the contents in this material have been subjected to careful check. For any mistakes and
omissions in printing or misunderstanding of the contents, the company keeps the right to inter-
pretation.
Addition: any technical improvements shall be placed in the revised manual without notice; for any
changes in appearance and color, those of the actual product shall prevail.
Measures for Emergency
1.- During using, if there are some abnormal cases, please unplug immediately and disconnect
power.
2.- For any failure of the product, please contact the special maintenance department or the
customer service center.
42