Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING
Batteries must only be changed in an area known to be non-
hazardous.
Do not mix battery manufacturers or old with new batteries.
Always use AAA alkaline batteries. Interspiro assumes no
liability for mechanical, electrical or any other type of battery
failure.
Cold conditions during storage and use will decrease battery
life.
1.
Remove the light head (c) by turning it counter clockwise.
2.
Insert three AAA batteries of alkaline type into the battery holder (d).
Make sure to put the batteries in the correct polarity direction. The
negative pole of the batteries goes on the spring in the holder. One battery
will be reversed, two in the same direction.
3.
Clean the O-rings (e) and lubricate them with silicone lubricant.
4.
Reassemble the light head by turning it clockwise.
Before use
1.
Assemble the light mount (b) to the Inodive slide (a) with two 6-32x 5/16"
phillips head screws (1).
2.
Assemble the Inodive light to the Inodive slide by tightening the screw on
the hose clamp (2) with a 6 mm wrench or a small screwdriver.
6
Interspiro Dive light
c
d
e
Werbung
Inhaltsverzeichnis
