Display Modes; When You Finish With Installation And; Adjusting The Display Settings; Position - Pioneer NavGate HUD SPX-HUD01 Installations- Und Kurzanleitung

Section
11

Display modes

12
Five types of view are available for this unit: AR view (low speed mode and high speed mode), list view (low
speed mode and high speed mode), junction view, route overview, and clock view.
If the communication between the unit and the navigation application is established, either of the following
views appears.
AR view
Low speed mode
High speed mode
If a vehicle approaches a junction
Route overview
If the button is pressed
when a destination is specified:
Notes
! The low speed mode of the AR view is dis-
played when a destination is not specified.
! For more details on the views, refer to the op-
eration manual.
18
Engb
List view
Low speed mode
Press ◀.
High speed mode
Press ▶.
If a vehicle approaches a junction
Junction view
Clock view
If the button is pressed
when a destination is not specified:
When you finish with installation and connection

Adjusting the display settings

When you finish with the installation and con-
nection, turn on the unit (start the vehicle en-
gine) and adjust the combiner angle so that the
image can be seen.
Note
The screen may not be able to be seen clearly
depending on the screen brightness and sur-
rounding conditions. Adjust the screen bright-
ness properly (refer to Adjusting the display
brightness on page 20), or move the vehicle to a
location where the display is more clearly visible,
and then operate the unit.
1 Press the button.
2 Press the a/b button to select Display
Settings, and then press the d button.
3 Press the a/b button to select a setting
item, and then press the d button.

Position

Adjust the position of the displayed image.
1 Press the a/b button to select a setting
item, and then press the d button.
Setting item Description
Select to adjust the horizon-
Horizontal Posi-
tal position of the displayed
tion
image.
Select to adjust the vertical
Vertical Position position of the displayed
image.
2 Press the a/b button to display the grid
pattern in its entirety.
Ex.: When it is correctly adjusted
Ex.: When it is not correctly adjusted

Zoom

Adjust the size of the displayed image.
% Press the a/b button to display the grid
pattern in its entirety.