Product Constitution; Assemble Processes - Modster FLASH HOTLINER Betriebsanleitung

Product constitution

Fuselage, Main Wings, Horizontal Wings,
Connecting Rod for Horizontal Wings, Connecting
rod for Main Wings

Assemble processes

Assembly of the Horizontal Wings
1.
Take the horizontal wings & the connection rod for the horizontal wings and install them to the assembling
groove at the tail parts of the fuselage in the right position. Then lock the horizontal wings by screws.
Assembly of the Main Wings
2.
Take the Main wings & aileron servo, Y-wire & connection rod for the main wings & Screws. Firstly, please
insert the connecting rod into right and left main wings and connect them. Then please connect the aileron
servo with the receiver by the Y-cable. Finally, please put the assembled main wings to the right position on
the back of the fuselage and lock them by the screws. Please make sure, there is no gap or shaking.
Close the canopy - and the assembly of the "MODSTER FLASH" is finished!
3.
2