First Use; Set The Water Softener - Electrolux ESI 68850 Benutzerinformation

For submenu marked with (*)
• Press OK, the current setting flashes indi-
cating that it can be modified.
• Repeatedly press one of the up and down
scrolling buttons to select the new setting.
• Press OK or wait a few seconds to store
the setting.
Key lock
With this function active, 15 seconds after
the last selection the buttons are locked and
controls cannot be used.
It is possible to temporarily deactivate
the function, press and hold any button,

First use

Before using your dishwasher for the first
time:
• Ensure that the electrical and water con-
nections comply with the installation in-
structions
• Remove all packaging from inside the ap-
pliance
• Set the water softener level

Set the water softener

The dishwasher is equipped with a water
softener designed to remove minerals and
salts from the water supply, which would
have a detrimental or adverse effect on the
operation of the appliance.
The higher the content of these minerals and
salts, the harder your water is. Water hard-
ness is measured in equivalent scales, Ger-
man degrees (dH°), French degrees (°TH)
and mmol/l (millimol per litre - international
unit for the hardness of water).
The softener should be adjusted according
to the hardness of the water in your area.
Your local Water Authority can advise you on
the hardness of the water in your area.
The water softener must be set in two
ways: manually, using the water hard-
ness dial and electronically.
Setting manually
The dishwasher is factory set at position
2.
1. Open the dishwasher door.
a displayed message guides you in the
deactivation of the key lock function.
After 15 seconds the function will be ac-
tivated again.
To deactivate the key lock function, go
to menu options and change the setting.
• Pour 1 litre of water into the salt container
and then fill with dishwasher salt
• Fill the rinse aid dispenser
If you want to use combi detergent
tablets such as: ''3 in 1'', ''4 in 1'', ''5
in 1'' etc... set the Multitab function.
(See ''Multitab function'').
2. Remove the lower basket from the dish-
washer.
3. Turn the water hardness dial to position
1 or 2 (see chart).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level 5.
Enter Menu options - Settings - Water
hardness.
Using the up and down scrolling buttons set
the level of the water softener according to
the hardness of the water in your area (see
chart).
electrolux 79