Lindemann LIMETREE BRIDGE II Bedienungsanleitung Seite 26

26 EN
GETTING STARTED
be upscaled to the highest possible sample rate of the connec-
ted digital input using a multiplication by 1, 2 or 4. In general the
Limetree BRIDGE uses a synchronous re-sampling with a multipli-
cation/division factor of 2. That way asynchronous up- or down-
sampling is avoided which, due to interpolation errors, would
Input
sample rate
Native
Mode 48 kHz
44,1 kHz 44,1 kHz
48 kHz 48 kHz
88,2 kHz 44,1 kHz
96 kHz 48 kHz
176,4 kHz 44,1 kHz
192 kHz 48 kHz
352,8 kHz 44,1 kHz
384 kHz 48 kHz
Output sample rate
Limit Limit
96 kHz
44,1 kHz
48 kHz
88,2 kHz
96 kHz
88,2 kHz
96 kHz
88,2 kHz
96 kHz
normally produce additional "jitter". With a 48 kHz limit the two mo-
des are not any different (see table). The question which mode yields
the better sonic result will also largely depend on the connected
D/A converter. In the LINDEMANN app you will find these settings
under Settings > Device settings > SRC mode.
Input
sample rate
Limit Up-sampling
192 kHz Mode
44,1 kHz 44,1 kHz
48 kHz 48 kHz
88,2 kHz 88,2 kHz
96 kHz 96 kHz
176,4 kHz 176,4 kHz
192 kHz 192 kHz
176,4 kHz 352,8 kHz
192 kHz 384 kHz
Output sample rate
Limit Limit
48 kHz 96 kHz
44,1 kHz 88,2 kHz
48 kHz 96 kHz
44,1 kHz 88,2 kHz
48 kHz 96 kHz
44,1 kHz 88,2 kHz
48 kHz 96 kHz
44,1 kHz 88,2 kHz
48 kHz 96 kHz
Limit
192 kHz
176,4 kHz
192 kHz
176,4 kHz
192 kHz
176,4 kHz
192 kHz
176,4 kHz

192 kHz
Top