Disposing Of The Packaging; Disposing Of Your Old Refrigerator; Placing And Installation - Beko RSSE445K21WN Bedienungsanleitung

Installation

Disposing of the packaging

The packing
dangerous for children. Keep the packing
materials out of the reach of children or
dispose of them by classifying them in
accordance with the waste instructions
stated by your local authorities. Do not
throw away with regular house waste,
throw away on packaging pick up spots
designated by the local authorities.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
• You may consult your authorized dealer
or waste collection center of your
municipality about the disposal of your
refrigerator.
Before disposing of your refrigerator,
cut out the electric plug and, if there
are any locks on the door, make them
inoperable in order to protect children
against any danger.

Placing and Installation

A
If the entrance door of the room
where the refrigerator will be installed
is not wide enough for the refrigerator
to pass through, then call the authorized
service to have them remove the doors
of your refrigerator and pass it sideways
through the door.
1. Install your refrigerator to a place
that allows ease of use.
2. Keep your refrigerator away from
heat sources, humid places and direct
sunlight.
Refrigerator/User Manual
materials may
3. There must be appropriate air
ventilation around your refrigerator in
be
order to achieve an efficient operation.
If the refrigerator is to be placed in a
recess in the wall, there must be at least
5 cm distance with the ceiling and at
least 5 cm with the wall. Do not place
your product on the materials such as
rug or carpet.
4. Place your refrigerator on an even
floor surface to prevent jolts.
5. Your product requires adequate
air circulation to function efficiently.
If the product will be placed in an
alcove, remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
6. If the product will be placed in
an alcove, remember to leave at least
5 cm clearance between the product
and the ceiling, rear wall and the side
walls. Check if the rear wall clearance
protection component is present at its
location (if provided with the product).
If the component is not available, or if it
is lost or fallen, position the product so
that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
11 / 22 EN