Fitting Instructions; Care Instructions; Storage Instructions - Medi M.step Gebrauchsanweisung

English

Fitting instructions

• Adjust the heel width. Position the heel rest with the hook and loop
strap so that the side pieces hug the ankle closely. (Fig. 1)
• Open all the straps and fasteners.
• Hold the injured joint at 90°. Put the brace on so that the heel is in the
centre of the heel rest and the side pieces hug the ankle closely.
(Fig. 2)
• Now fasten the lower fastener. Make sure that the side pieces remain
parallel. (Fig. 3)
• Close the upper strap.
• Pull one or both straps tight alternately until the brace fits firmly.
Make sure it does not press too tightly on the ankle joint. (Fig. 4)

Care instructions

Hook and loop fasteners should be closed for washing. Soap residues,
lotions and ointments can cause skin irritation and material wear.
• Wash the product by hand, preferably using medi clean washing
agent.
• Do not bleach.
• Leave to dry naturally.
• Do not iron.
• Do not dry clean.
    

Storage instructions

Keep the product in a dry place and do not expose to direct sunlight.
Material composition
Polyurethane, polyester
Liability
The manufacturer's liability will become void if the product is not used
as intended. Please also refer to the corresponding safety information
and instructions in this manual.
Disposal
The product can be disposed of in the domestic waste.