Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT: To protect the turntable from damage during transport, there is
a silver transport screw on the right above the turntable. Before you start
playing, completely screw in the screw with a screwdriver.
Play turntable
1.
Press the PHONO button (31) to switch to "Record" mode.
2.
Place a record on the PLATE (36).
3.
If you want to play a 17cm EP, place the SINGLE ADAPTER (23) on the
TURNTABLE (36) before placing the formwork panel.
4.
Set the SPEED SELECTOR (24) to 33/45 or 78 RPM, according to the
record.
5.
Unlock the TONE ARM CLAMP (22) and remove the protective cap from
the tone needle.
6.
Use the TONE ARM LEVER (16) to lift the tonearm.
7.
Move the tonearm to the beginning of the record or a specific track.
8.
Use the TONE ARM LEVER (16) to gently lower the tonearm onto the
record to start playback.
9.
If you want to stop the record during playback, lift the tonearm off the
record and swing it back to the TONE ARM STORAGE (25).
Note:
Do not turn, stop, or block the platter by hand or otherwise. If you move or push the
platter without securing the tone arm with the TONE ARM CLAMP (22), the tone
arm could be damaged. Put the protective cap on the clay needle when the device
is not in use.
REMARKS:
When the playback is finished, the TURNTABLE (36) stops automatically.
Use the TONE ARM LEVER (16) to carefully lift the tonearm off the
record and swing the tonearm back to the TONE ARM STORAGE (25).
33
Werbung
Inhaltsverzeichnis
