Operation - Villager FALCON 6111 B-MATIC Originalbetriebsanleitung

Villager FALCON 6111 B-MATIC (GB)
Adjusting the throttle cable: Illustration A1-3
If you experience slack in revolution cable, this can be solved simply by tighten or
loosen the bolt on the engine block.

Operation

Always check and refill oil before the start!
Read and apply the instructions given in the enclosed start guide!
The oil level should always be between min. and max on the dipstick. Fill with SAE-
30 oil. There should be total 0.6 liter oil in the engine. Use only unleaded 95 octane
fuel to the engine. Never overfill the tank.
Cutting height adjustment: Illustration F1
(the illustrations may vary from your actual model)
The mower has 6 different heights. The cutting height ranges from 28 mm to 75
mm.
Start: Never start the mower directly on long grass.
Recoil with primer: Illustration F2
1. Push the primer several times, first time push 1-3 times, if necessary supplement
with up to 3-5 times. Note: It is not possible to drown engine.
2. Hold the handlebar for the engine brake; this will release the engine brake.
3. Pull the recoil starter gently until you feel resistance in the rope, then pull quickly
and energetic. Do not at any time let go of the recoil starter but slide it gently into
starting position.
4. Hold the bar for self-propelled in order to start mowing.
Recoil with choke, throttle lever: Illustration F3-A
1. By cold engine set the choke lever on "Choke"- By warm engine set the choke
lever on "Run".
2. Move the throttle lever to full "Rabbit" (A).
3. Hold the handlebar for the engine brake; this will release the engine brake.
4. Pull the recoil starter gently until you feel resistance in the rope, then pull quickly
and energetic. Do not at any time let go of the recoil starter but slide it gently into
starting position.
5. Adjust the throttle lever if necessary and return the choke lever in the "run"
position. (only cold engine).
6. Hold the bar for self-propelled in order to start mowing.
16