Electrical Connection; Extraction Mode / Recirculation Mode; Extraction Mode; Recirculation Mode - Wolkenstein W P1-60A IXEZ Bedienungsanleitung

10. Fix the top chimney on the installation bracket (look also on step 8).
11. Insert the grease filters and connect the appliance to the mains
Check the correct position of the hood from front and side perspective.
Otherwise the appliance will not work properly.

2.4 Electrical connection

Check that the voltage indicated on the rating plate matches the mains voltage of
your home before connecting the extractor hood to the mains.
Check that the extractor hood is installed properly before you connect the
appliance to the mains.

3. Extraction mode / Recirculation mode

3.1 Extraction mode

WARNING! Do not lead the exhaust air into a chimney which is used
for extracting exhaust air of appliances operated by gas or other
combustibles.
❖ In extraction mode, the intake air is led through an exhaust hose to the outside.
For this purpose, an exhaust shaft or an outwardly leading exhaust pipe must be
available in your house / flat.
If your appliance is equipped with a carbon filter, you must remove the carbon
filter before you operate the appliance in the extraction mode!

3.2 Recirculation mode

❖ You can also use the appliance in recirculation mode.
❖ In recirculation mode, the exhaust air is led back into the kitchen.
❖ If you want to use the extractor hood in recirculation mode, you have to install
the carbon filters; s. chapter 3.2.1 C
If the socket is covered by the chimney, you must plug in the appliance at an earlier
8
point in
time.
.
ARBON FILTERS
8 .
41