Sharp UA-KIL80E Bedienungsanleitung Seite 17

HUMIDIFYING FILTER / HUMIDIFYING TRAY
1. Remove the
Humidifying
Filter and Tray.
2. Rinse with plenty of water.
• Do not remove the Float and the
Rollers. If they come off , refer to
below.
3. Attach the Humidifying
Filter and Tray.
• After maintenance, correctly
reattach the parts.
NOTE
How to clean hard to remove dirt.
Kitchen detergent
(only Humidifying tray)
1. Fill the tray half-way with
water.
1
2. Add a small amount of
kitchen detergent.
Soak for 30
2
minutes.
3
NOTE How to install the Float and the Rollers
Float
3. Insert the tab on the other
3. Insert the tab on the other
side of the float into the
side of the float into the
hole.
hole.
2. Insert the tab of the float into
2. Insert the tab of the float
the hole.
into the hole.
Citric acid
(available at some drugstores)
2 1/2 cups of water
Rinse off the kitchen detergent or the descaling solution with clean water.
1. Insert the Float under this
tab.
100% bottled lemon juice
3 cups of water
3 teaspoons
Tab
Float
Cross-Section view
EN-15
Tray Panel
Float
Roller
with no pulp
1/4 cup
Soak for 30 minutes.
(When using lemon juice as your
descaling solution, allow for more
soak time.)
Roller
Click
Click