Haier HW8 0-B1439N Bedienungsanleitung Seite 20

8-Care and cleaning
8-6
Note: Hygiene
After long periods of disuse we recommended to run programme HYGIENE with no
load and small amount of detergent in washing agent compartment (2) or special ma-
chine cleaner to remove possibly corruptive residues.
8-8
8-10
8-12
20
8.5 Long periods of disuse
8-7
If the appliance is left idle for a longer period:
1. Pull out the electrical plug (Fig. 8-6).
2. 7XUQ R ZDWHU VXSSO\ )LJ  
3. Open the door to prevent formation of moisture
Before next usage check carefully power cord, water
inlet and drain hose. Make sure everything is properly
installed and without leakage.
 3XPS OWHU
8-9
&OHDQ WKH OWHU RQFH D PRQWK DQG FKHFN WKH SXPS OWHU
for instanvce if the appliance:
▶
▶
▶
6FDOGLQJ 5LVN :DWHU LQ WKH SXPS OWHU FDQ EH YHU\
8-11 KRW %HIRUH DQ\ DFWLRQ SOHDVH HQVXUH ZDWHU KDV
cooled down.
1. 7XUQ R DQG XQSOXJ WKH PDFKLQH )LJ  
2. 2SHQ VHUYLFH DS <RX FDQ HLWKHU XVH D FRLQ RU D
3. 3URYLGH D DW FRQWDLQHU WR FDWFK OHDFK ZDWHU
4. Pull the drainhose out and hold its end above the
8-13
5. Take the sealing plug out of the drainhose (Fig.
6. After complete drainage close drainhose (Fig.
7. 8QVFUHZ DQG UHPRYH FRXQWHU FORFNZLVH WKH
8. Remove contaminants and dirt (Fig. 8-13).
and odours. Let door open while not used.
Doesn´t drain the water.
Doesn´t spin.
Cause unusual noise while running.
WARNING!
screwdriver (Fig. 8-9).
)LJ   7KHUH FRXOG EH ELJJHU DPRXQWV
container (Fig. 8-10).
8-10).
8-11). and push it back into the machine.
SXPS OWHU )LJ  
EN