Configuration - Default Settings; Relay Configuration - Abus MODUVIS TVHS20 Serie Bedienungsanleitung

Adding an ABUS Network camera
To add an ABUS network camera to the system, please click the "+" symbol at the top right under
"Add device".
Select "Private protocol" for ABUS cameras and assign a device name of your choosing. The IP
address of the camera in the network and the RTSP port (default 554) are also required for
connection. Then you still need to enter the username and password for your network camera.
The list of compatible ABUS network cameras can be found at www.abus.com.
5.2.4.4 Configuration – default settings
Default settings:
Factory settings:
5.2.5

Relay configuration

Relay 1
Duration
Interval
Relay 2
Under "Relay configuration", the two monitor relays themselves are configured. The configuration
in this menu has no impact on the video door module relay.
The relay outputs are on the back of the monitor and can be connected via the enclosed splitter
cable. The assignment is printed on the back of the monitor.
The relay 1 is switched between COM1 and NO1, relay 2 is connected to COM2 and NO2.
Button/display
Relay 1
Duration
Interval
Resets the monitor to default settings. It will still be activated and
the password will remain the same.
Completely resets the monitor including password to factory
settings. The monitor will then be in "inactive" status.
Relay configuration
Description
Activates/deactivates
additional (or already existing) doorbell. The
relay 1 on the monitor is triggered in parallel to
a call.
Determines how long the relay for the
additional doorbell is triggered when pressed.
Determines the interval in which the relay is
triggered for the set "duration" of the additional
doorbell when pressed.
120
3s
5s
the function for an