English; Kfs135 Tiltable Trimmer - Virutex WEGOMA KFS135 Gebrauchsanweisung

E N G L I S H

KFS135 TILTABLE TRIMMER

Important
Read these OPERATING INSTRUCTIONS
and the attached GENERAL SAFETY
INSTRUCTIONS LEAFLET carefully before
using the machine. Make sure you have
understood them before operating the
machine for the first time. Keep both
sets of instructions for any future queries.
1. SAFETY INSTRUCTIONS FOR USING THE ROUTER
Carefully read the GENERAL SAFETY
INSTRUCTION LEAFLET enclosed with the
machine documents.
2. Before plugging in the machine, make sure that the
power supply voltage is the same as that shown on the
specifications plate.
3. Always keep your hands away from the cutting area.
Always grip the machine safely.
4. Use protective goggles.
5. Always use original Wegoma by Virutex tools. Never
use defective or damaged tools.
6. Always use cutter bits with the appropriate stem
diameter for the chuck collet and tool speed to be used.
Unplug the machine from the power
supply before performing any mainte-
nance operations.
2. SPECIFICATIONS
Input power...........................................................................750 W
Universal motor.........................................................50/60 Hz
No-load speed...........................................14,000 – 30,000/min
Ø max bit..........................................................................25 mm
Ø standard chuck collet..................................................6 & 8 mm
Weight................................................................................2.2 Kg
Weighted equivalent continuous
acoustic pressure level A...................................................83 dBA
Acoustic power level A......................................................94 dBA
Uncertainty......................................................................K = 3 dbA
Wear ear protection!
Vibration total values.................................................a
Uncertainty....................................................................K: 1.5 m/s
16
3. STANDARD EQUIPMENT
Inside the carrying case the following items will be found:
• KFS135 Router with 8 mm collet (*)
• Straight cutter for trimming and slotting D.18 LC. 20
• Key: 11 mm for motor shaft.
• Key: 19 mm for chuck collet attachment.
• Copying device
• Bit bearing brake
• Lateral square with centring shaft
• 3-mm Allen wrench
• Operating instructions and other documents
(*) (Machines at 120 V are equipped with 6.35 mm
(1/4") collet.)
4. GENERAL DESCRIPTION OF THE ROUTER
The KFS135 router can be used for trimming laminates,
shaping small mouldings, rabbeting, making straight
cut-outs, chamfering, etc. Its head may be tilted from
0 to 91.5° to cut bevelled edges and chamfer using
cylindrical cutters plus many more applications.
It micrometric copying wheel also allows interior curves
with radii over 52 mm to be cut.
It can also cut copies from templates using the copiers or
the template guides shown in section 11 and it can cut or
shape circles using the lateral square and centring shaft.
5. ASSEMBLY OF THE ROUTER AND ITS ACCESSORIES
5.1 ASSEMBLING AND CHANGING THE CUTTER
To change or assemble a cutter in the machine (Fig.
1), block the motor shaft using the key U, unscrew the
nut using the service key Z, take out the used cutter
and attach the new one placing it into the bottom of
its housing and then tighten using the service keys.
5.2 ASSEMBLING THE FEELER AND BRAKE
: 3.1 m/s
2
h
2
Make sure you place the chuck collet in
the correct position, otherwise vibrations
may occur or the part itself my come
loose (Fig. 23).
Disconnect the machine from the power
supply before assembly.
Check that the stem diameter of the
chuck collet matches that of the cutter
stem to be used.
Disconnect the machine from the power
supply before assembly.