JVC RM-LP55 Bedienungsanleitung Seite 8

OPERATION (continued)
W.PAINT GAIN SHUTTER IRIS MANU
MENU FUNC1
B C
o GENLOCKING MODE ADJUSTMENTS
●
Controls SC phase and horizontal phase
during genlocking
1.
Select A3: SC FINE COARSEB using MENU
button B (SC phase adjustment).
3 : SC FINE COARSE
0
SC FINE SC COARSE
2.
Set the SC COARSE using FUNC2 button D
(0°, 90°, 180° and 270°).
3.
Fine-adjust the SC phase using FUNC1 button
C (–128 to +127).
To fine-adjust in the +
direction.
To fine-adjust in the –
direction.
If the button is held depressed, the level will
●
vary in 10 steps.
4.
Select A4: H.PHASEB using MENU button B
(horizontal phase adjustment).
4 : H. PHASE
Horizontal phase
5.
Adjust the horizontal phase using FUNC1
button C (–128 to +127).
● If the button is held depressed, the level will
vary in 10 steps.
To adjust phase in the
+ direction.
To adjust phase in the
– direction.
E-8
All manuals and user guides at all-guides.com
OPERATE
ENTER
FUNC2
/SET
D E
0°
Select ASC COARSEB
FUNC1 FUNC2
0
FUNC1
o GAMMA CORRECTION (ON/OFF)
●
Set to ON to correct gamma or to OFF when
gamma correction is not required.
1.
Select A5: GAMMAB using MENU button B.
2.
Set to ON or OFF using FUNC2 button D.
Set ON or OFF.
5 : GAMMA
o AUTO IRIS DETECTION MODE
●
Three modes are available:
NORMAL : Detection is based on a
combination of peak value and
average value.
PEAK : The peak value is detected, and
the optimum iris level is
adjusted.
AVG : The average value is detected,
then the optimum iris level is
adjusted.
1.
Select A6: IRIS DETECTB using MENU button
B.
6 : IRIS DETECT
2.
Select the detection mode using FUNC2 button
D.
● Each time is pressed, the mode changes
from NORMAL N PEAK N AVG N NORMAL
N...; pressing
changes the modes in
reverse order.
Select a detection
mode.
FUNC2
ON
Mode indication
NORMAL
FUNC2