JVC RM-LP55 Bedienungsanleitung Seite 16

OPERATION (continued)
B C D
MENU FUNC1
FILE W.BAL
F
WHITE PAINT
R B
MASTER BLACK
O
o LENS IRIS CONTROL
●
Operates the iris of the lens mounted on the
camera.
Auto iris
1.
Press IRIS AUTO/MANU button M to set to the
auto iris mode (the IRIS MANU LED is not lit).
2.
Set whether to adjust the auto iris level using
the IRIS control N at AAUTO IRIS LEVELB.
(AREMOTE CONTROLLER OPERATION
MODE SETTINGSB (A pg. 18))
If the camera's LENS switch is set to AMANUB,
●
the auto iris will not function.
Switch between auto
and manual.
Auto iris mode: serves as a precise auto iris level
control. Manual iris mode: serves as
an iris level control.
Manual iris
1.
Press IRIS AUTO/MANU button M and set to
the manual iris mode. (The IRIS MANU LED is
lit.)
2.
Using IRIS control N, the iris level can be
controlled (between near CLOSE position and
OPEN position).
E-16
All manuals and user guides at all-guides.com
E
ENTER
FUNC2
/SET
GAIN SHUTTER
IRIS
AUTO/MANU
M
IRIS
N
CLOSE OPEN
IRIS
AUTO/MANU
IRIS
CLOSE OPEN
NOTE:
When Gain in set to AALC + EEIB or AALCB, or
when the shutter mode is set to AEEIB, the iris
mode is automatically set to auto iris. In this case,
manual iris operation is not possible.
When the above settings have been set, change the setting
at ALC IRIS SET to perform manual iris operation.
(A pg. 18, AREMOTE CONTROLLER
OPERATION MODE SETTINGSB)
o MASTER BLACK LEVEL CONTROL
●
Controls the black level of the camera signal.
Use the MASTER BLACK control O to adjust
●
the black level.
● Turn clockwise to increase the black level; turn
counterclockwise to decrease the level.
o SCENE FILE FUNCTION
●
To store setting data in the Scene File (A/B) or
to call up data stored in the Scene File (A/B)
and apply it to the connected camera.
Writing data into Scene File
1.
Press FILE button F.
The AFILEB screen will appear on the LCD.
●
FILE
SCENE A WRITE
Press FILE button.
2.
Press FUNC1 button C to select either
SCENE A or SCENE B.
Select either the
ASCENE AB or ASCENE BB:
3.
Press FUNC2 button D to select AWRITEB.
Set to AWRITEB.
4.
Press ENTER/SET button E.
● The LCD shows ASCENE FILE A (or B) WRITE OK?B
SCENE FILE A
WRITE
5.
Press ENTER/SET button E again if it's OK.
● The LCD changes to ASCENE FILE A (or B)
WRITING!B. The setting data is stored in memory.
● If you don't want to execute writing. press
MENU button B to cancel.
SCENE FILE A
WRITING!
FILE
FUNC1
FUNC2
OK?