Conrad Electronic Fidek Power Endstufe 2 x 1500W Bedienungsanleitung Seite 29

Connect the loudspeakers A with the
loudspeaker connections of channel A.
Connect loudspeakers B with the loud-
speaker connections of channel B.
Examples for connection:
Here the power amplifier is used to amplify 4 loudspeakers. 2 loudspeakers each
form a group. The total impedance of each loudspeaker group may not be below 4
Ohm in this operating mode, so use 8 Ohm speakers with this constellation.
34
Connect the positive pole of loudspeak-
ers A with the red loudspeaker output
clamp marked with "CH-A OUT +" (13)
and the negative pole of loudspeakers A
with the black loudspeaker output
clamp marked with "CH-A OUT –" (13).
When using the SPEAKON connections,
connect the SPEAKON line of loud-
speakers A with the loudspeaker output
SPEAKON CH-A OUT (12).
Connect the positive pole of loudspeak-
ers B with the red loudspeaker output
clamp marked with "CH-B OUT +" (13)
and the negative pole of loudspeakers B
with the black loudspeaker output
clamp marked with "CH-B OUT –" (13).
When using the SPEAKON connections,
connect the SPEAKON line of loud-
speakers B with the loudspeaker output
SPEAKON CH-B OUT (12).
Connect the right speaker with the loud-
speaker connections of channel B.
Examples for connection:
2 loudspeakers are connected here per channel. The total impedance per channel
may not be below 4 Ohm in this operating mode, meaning you have to use loud-
speakers with an impedance of at least 8 Ohm.
Connect the positive pole of the right
loudspeaker with the red loudspeaker
output clamp marked with "CH-B OUT
+" (13) and the negative pole of the right
loudspeaker with the black loudspeaker
output clamp marked with "CH-B OUT
–" (13).
When using the SPEAKON connections,
connect the SPEAKON line of the right
loudspeaker with the loudspeaker out-
put SPEAKON CH-B OUT (12).
31