Getting Started P; Charging The Battery P - BWT BC50 Bedienungsanleitung

GETTING STARTED
Charging the battery
IMPORTANT NOTE: Fully charge the pool vacuum (about 6 hs) before using
it for the first time.
WARNING!
Use only the original external adaptor and charging base provided.

Make sure the pool vacuum and the charging contact plates are clean

and dry before set-up and charging. (TIPS: Use a cotton bud to dry the
charging contact plates)
Charging must be done indoors, in a well-ventilated area away from

sunlight, children, heat, ignition sources, and with an ambient
temperature between 5˚C (41˚F) and 35˚C (95˚F).
Never use the external adaptor and charging base if any damage is

detected.
The charging contact plates are waterproof. However, remnants of water

on the contact plates could result in natural occurrence of stains (a
byproduct of chemical reaction between water and electric currents).
Otherwise, the stains can be removed by light scrubbing with a cotton
bud soaked with juice of lemon or vinegar.
Make sure that the pool vacuum is turned off prior to charging.

1. Place the unit on a flat surface. Make sure the pool vacuum is off by
turning the power ON/OFF switch to the OFF position prior to charging.
2. Turn the locking knob (on each side) anticlockwise until it points to the
green dot marking (unlock position) to unlock and release the rear body
from the transparent canister.
MAINTENANCE & CLEANING 7 2021/02 : A