Troubleshooting - BWT BC50 Bedienungsanleitung

TROUBLESHOOTING

Problem
Pool vacuum does not capture the
debris
Debris escapes from the filter
Debris goes outside the filter cone
Handle / pole connector cannot be
secured in assembly
Pool vacuum cannot be charged /
recharged
Suction head does not move
smoothly
Pool vacuum is activated even
though the switch indicates it's off.
Operation time is shorter as
expected
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly
recycles electrical and electronic equipment. Do not dispose them in unsorted waste bins. For items
containing removable batteries, remove batteries before disposing of the product.
BWT Holding GmbH
© 2020
All rights reserved. No part of this document may be reproduced or transmitted in any form or by any
means, electronic, mechanical, photocopying, recording, or otherwise, without prior written
permission. (V2)
If soft copy of this instruction manual is required, please contact our customer service by email.
SAVE THESE INSTRUCTIONS
MAINTENANCE & CLEANING
Possible Cause
Battery is running out
Impeller is jammed
Impeller is broken
Filter is full
Larger debris / large
volume of debris
Suction nozzle flap is
broken
Filter net is damaged
Outlet valve comes off
Side pin is broken
Battery is damaged
Contact plates of the
charger base and unit are
not connected.
External adaptor is out of
order
Wheel is jammed
Presence of magnetic
objects nearby has
inadvertently switched on
the motor.
Battery is not fully charged
17
Solution
Charge the battery again.
Power off the pool vacuum and visually check the
gap in middle of the pool vacuum to see if the
impeller is jammed by larger debris. If possible, use a
small tool to remove it with intensive care & caution.
If necessary, contact your dealer for further
instructions.
WARNING!
Make sure the pool vacuum is
powered off when the unit is being serviced.
Contact your dealer for impeller replacement.
Clean the filter cone if applicable.
Remove the pivoting suction head (not
recommended for SPAs as it could scratch the spa
surface.)
Suction nozzle flap works like a door to prevent the
debris from escaping from the filter. Contact dealer
for replacement parts and instruction.
Replace with a new filter cone.
Without the outlet valve, the pool vacuum might
capture debris through this opening. Contact dealer
for valve replacement.
Replace with a new handle / pole connector.
Contact dealer for battery replacement.
WARNING!
DO NOT open the pool vacuum
and replace the battery by yourself. This could result
in severe or fatal injuries and the warranty will be
voided as a result.
Make sure that the charger base is assembled on the
unit properly so that their contact plates are touching.
Contact dealer for replacement.
WARNING!
Using the wrong external adaptor
will result in damaging the pool vacuum / battery and
voiding the warranty as a result.
Clean out the debris from the wheel.
Move the magnetic objects or vacuum away from
each other.
Charge the pool vacuum for at least 6 hrs. NOTE: if
any stains are found on the charging contact plates,
remove them by using a cotton bud soaked with
lemon juice or vinegar
20011012
2021/02 : A