Battery Disposal P - BWT BC50 Bedienungsanleitung

Make sure to drain the water from the handle through its hole on the bottom end.

Use a damp cloth to clean and dry the pool vacuum and its accessories.

Store them in a well-ventilated area away from the sunlight, children, heat, ignition

sources, and pool chemicals. Ambient temperature for storage should be 10˚C – 25˚C
(50˚F – 77˚F). NOTE: A higher temperature may reduce the battery life during storage.
WARNING!
- Never attempt in any way to disassemble the pool vacuum.
- Under no circumstances should you attempt to disassemble the pool
vacuum and replace the impeller, motor and battery by yourself.
CAUTION!
 Excessive heat can damage the battery and reduce its lifespan as a result.
Consult your dealer regarding battery replacement if the following happens:
- Battery does not charge fully.
- Battery operation time is noticeably reduced. Observe and record the run times of the
first few operations (on a full charge). Use these run times as a reference point for
comparison with run times in the future.
 The battery must be removed from the pool vacuum before it is scrapped.
 The pool vacuum must be disconnected from the supply mains when removing the
battery
 The battery is to be disposed safely and according to local ordinances or regulations.
NOTE: Incorrect maintenance may reduce the battery life and affect its capacity as a
result.
BATTERY DISPOSAL
Your pool vacuum battery is a maintenance-free rechargeable lithium-ion battery pack,
which must be disposed properly. Recycling is required; please contact your local
authority for information.
WARNING!
Never attempt to disassemble a battery pack
Remove all personal items such as rings, bracelets, necklaces and

watches when the battery pack is unwired from the pool vacuum.
A battery can produce a short circuit current high enough to weld a ring

(or similar item) to metal, causing a severe burn in the process.
Wear complete eye protection, gloves and protective clothing when the

battery pack is being removed.
Avoid touching the wires altogether and avoid allowing them to make

MAINTENANCE & CLEANING
(To be carried out by an authorized technician)
14 2021/02 : A