Maintenance & Storage P - BWT BC50 Bedienungsanleitung

CAUTION! Replace a damaged filter cone immediately with a new one before the next
operation.
6. To re-position the transparent canister (with filter cone inside) onto the rear body,
make sure the locking knob on each side is turned to the unlocked position. Align the
raised arches on both sides of the transparent canister with the locking knobs and
turn each knob clockwise until it points towards the red marking to secure the
assembly. Attention: The case has one correct position only. The water-draining
valve must be facing the bottom when holding the cleaner horizontally by the handle.
MAINTENANCE & STORAGE
NOTE:
1. Be sure to clean and dry the charging contact plates after every use to avoid the
forming of stains (byproduct of a natural chemical reaction between electric current
and water). Otherwise, the stains can be removed by light scrubbing with a cotton bud
soaked with juice of lemon or vinegar.
2. Battery discharges on its own during storage. Make sure to charge the pool vacuum
to about 30% to 50% of the battery capacity before it is stored.
3. You must re-charge the battery at least once every three months when it is not in use.
Unplug the external adaptor from socket and then unplug the adapter jack from the

charging base.
Detach accessories from the pool vacuum. If necessary, rinse the pool vacuum and

accessories with fresh water. DO NOT use detergent.
Make sure to drain the water from the rear body through the holes located inside

the chamber that connects to the handle/ pole connector, and the hole on the rear
of the body.
MAINTENANCE & CLEANING 13 2021/02 : A